What's with the white smoke in the car?

The reason why cars emit white smoke is because there is too much water in gasoline, or the gasket of waterway is damaged, and the cylinder liner is damaged, which is caused by cooling into the water tank.

If the gasket is damaged, you need to go to the maintenance center to replace the cylinder gasket. If there is too much water, it will have a bad influence on the car engine.

Extended data:

Installation requirements of automobile gasket:

1, sealing gasket and flange sealing surface should be cleaned, and there should be no defects such as scratches and spots that affect the sealing performance of the connection.

2. The outer diameter of the gasket should be smaller than the outer diameter of the flange sealing surface, and the inner diameter of the gasket should be slightly larger than the inner diameter of the pipeline. The difference between the inner diameters of the two is generally twice the thickness of the gasket, so as to ensure that the inner edge of the gasket does not extend into the container or pipeline after being pressed, and does not hinder the flow of fluid in the container or pipeline.

3. The pre-tightening force of the gasket should not exceed the design requirements, so as to avoid the gasket losing elasticity due to excessive compression.

4. When pressing the sealing gasket, it is best to use a torque wrench. For large bolts and high strength bolts, it is best to use hydraulic tensioners. The tightening torque should be calculated according to the given compression of the gasket, and the oil pressure of the hydraulic tensioner should also be determined by calculation.

5. When installing the gasket, tighten the nuts in sequence. But it should not reach the design value at one time. Generally, it should be circulated at least 2 ~ 3 times to make the stress distribution of sealing gasket uniform.

6. For pressure vessels and pipelines containing flammable and explosive media, safety tools should be used when replacing sealing gaskets to avoid sparks caused by collision between tools and flanges or bolts, resulting in fire or explosion accidents.

7. If the pipeline leaks, it must be decompressed before replacing or adjusting the installation sealing gasket. Operation under pressure is prohibited.

Baidu encyclopedia-gasket