Installation method of household switch socket
1, Guan Ying is 13. From the ground 150CM, from the edge of the door frame 15 to 20CM. Generally, a switch socket cannot be installed behind the door. The position of household switch with partition should be at least 0.2M away from the top of the board during pregnancy. When installing the switch socket, it should be higher than the ground 1.3M, and when installing the socket, it should be not less than 0.3m.. Of course, it is best not to install it on the bedside and desktop, so that the switch direction will be the same.
2, in the bathroom, balcony installation and repair of household switch socket should be equipped with splash-proof socket, or equipped with waterproof shell, its faucet, cooker, bathtub and gas meter around 20CM can not install its switch socket.
3. Household appliances strictly use two-hole sockets. In the bathroom, the power of the Yuba switch is high, so leave more room; ? Electrical appliances that usually need to be plugged and unplugged can use switch sockets.
4. When calculating the load rate, the socket without fixed load is generally calculated as 1000 watt, and the ordinary socket generally uses 2.5 square millimeters of copper core wire.
5. Connect the ground wire to the three hole socket, connect the phase wire to the right, connect the zero wire to the left, and do the same for both sockets.
6. To firmly install the household switch socket, the connector needs to be tightened.
7. Confirm that all wires are completely connected with switches and sockets during installation. Rear seat wiring stub contact.
8. When installing a household switch socket, the switch is usually opened and closed by the opposite hand, and the right hand has more objects than the left hand. Usually, on the left side of the door, the fluorescent switch is the best.
Tips: Before installing the household switch socket, protect the panel of the switch socket to avoid damage and pollution.
Introduction of household switch socket connection
1. If the household switch is used to control the on-off of the socket power supply, the connection method is as follows: firstly, connect the L end of the incoming switch (i.e. live wire inlet), then connect the L 1 end of the switch (i.e. live wire outlet) with the L end (i.e. live wire inlet) of the two-hole socket, and then connect the zero line to the N end (zero wire inlet) of the socket.
2. If the socket is not controlled by the switch, and the switch only controls the lamp, then the connection method is as follows: connect the live wire to the L end of the switch, connect the L 1 end of the switch to one end of the lamp holder, and connect the zero line to the other end of the lamp holder, so that the switch and the lamp form a loop. Then the live wire is connected to the L end of the two-hole socket, and the zero wire is connected to the N end of the socket, and the two-hole socket becomes another loop.
The above is the connection introduction of household switch socket introduced by Bian Xiao. First of all, Bian Xiao first introduces the installation method of household switch socket. You know, the installation of sockets is also very important. First of all, the socket must not be installed where children can easily touch it. If so, it is very dangerous. Finally, there is the problem of how to wire the household switch. You just need to pay attention to the details when you answer. Ok, that's all for Bian Xiao's introduction. Thank you.