The exhaust method after replacing antifreeze is as follows:
1, first add antifreeze to the calibration position.
There is a special exhaust valve in the upper corner of the water tank. Just open the exhaust valve after adding coolant. If there is no exhaust valve, open the cover of the cooling water tank. Let the car idle for 3-5 minutes and observe the liquid level. If it drops, replenish the liquid to the calibration position.
3. Tighten the coolant cover, drive normally for about 5 minutes, and check the liquid level.
4. After that, you can extend the inspection time and replenish the liquid if it is reduced.
Precautions:
Different kinds of antifreeze must not be mixed to avoid chemical reaction, precipitation or bubbles, because the consequence of doing so is to damage the rubber seal, which usually causes water seal and weld leakage of the pump. Therefore, the antifreeze of the same brand should be replenished in time after the antifreeze leaks. If there is no antifreeze of the same brand, distilled water or pure water can be temporarily replenished.
(Photo/Text/Photo: Li Caiying) @20 19