Don't throw away the discarded badminton, it is simple, lovely, practical and environmentally friendly.

Badminton is a worldwide sport. In life, many people love to play badminton, but the more they play, the more badminton they consume. When you pass by the playground, you can always see badminton discarded by the roadside. Some time ago, I saw a badminton pendant in my friend's car. I had a whim and tried to make a similar pendant. So as to share with you, it is a good example of waste utilization and an environmentally friendly lifestyle. If there are similarities, it is purely coincidental.

Please see the step decomposition ↓

1. Preparation tools: badminton, thread, scissors and screwdriver.

2. Trim badminton. Lose the badminton feathers. As shown, leave the frame part. And trim off the burr, so that the gap is not rough, otherwise it is easy to scratch the line.

3. Take out the thread and start knitting. As shown in the figure, the inside and outside are intertwined. After the first row is finished, continue to use the jack method. The small grid part of badminton needs three rows to finish.

4. After editing the small grid, continue to edit the large grid. Personally, I don't like the white line of badminton. Because the white line was not covered with a cross, it was surrounded by a circle of lines. The large grid part needs two rows of interweaving. The third row covers the edges of badminton by crossing. As shown in the figure:

The thread ends are all inside the sphere, so it will be stronger to burn the thread ends with a lighter.

The sphere is partially completed.

5. The next step is to punch holes. Use a screwdriver to make a hole in the badminton center. Very soft and easy to tie ~

6. Fold the thread in half, the length depends on your preference, and the double thread passes through the hole. Tie a knot in the middle of the line to fix the position of the badminton and prevent it from slipping. The bottom line can be matched with bells, tassels and so on.

A simple pendant is made. You can also continue to design according to your own creativity.

Put it on the edge of the table like a little doll sitting on the shore, so that the white part can be designed as the doll's head.

This pendant can be hung on the car, because it is light, avoiding the danger of using metal and glass as car pendants.

It can also be hung on a backpack as an accessory, which is beautiful and special.

In addition, with a few bigger bells, you can also hang them at home as wind chimes, and a gust of wind blows, which is crisp and pleasant.

Thank you for reading. I'm Liuery, a young woman who loves handicrafts.

If you get anything, please leave your comments, likes or rewards. Thank you~