The installation method of the shutter lock is as follows:
1. It is necessary to determine the installation height of the door lock of the rolling door equipment first, and then draw the center line of the lock on the door leaf.
2. When installing the shutter door lock, insert the lock core into the lock core hole from the outside of the door, put the prepared eye plate in the door, then straighten the lock core, and nail the eye plate and the lock core together with two long screws. Then put the lock body on the groove of the door body, so that the lock core plate can be directly inserted into the eyelet of the lock body, and then nail the lock body on the door leaf of the rolling shutter door with wooden screws.
3. Close the door leaf of the shutter door, insert the lock tongue into the box, then draw the approximate position of the lock tongue box on the door frame of the shutter door, cut a slot according to the drawn line when opening the door leaf, and then nail the lock tongue box on the door frame with wooden screws. The box should be lower than the lock tongue. The purpose of this is to install the shutter door properly when it sags in the future.
Extended data:
Precautions for replacing the quick door lock:
1. After selecting the lock cylinder, unscrew the two screws on the upper and lower sides of the hand panel. These two screws are mainly used to fix the panel. Just prepare a cross screwdriver, which is very simple. After tightening the screws, put the screws away, unscrew the lock core and put the screws on both sides of the sleeve. But be careful not to tighten these two screws too tightly when installing, so as to avoid the handle of the security door being too tight to open. Remove the handle first, and then remove the lock cap.
2. Put the lock cylinder into the sleeve and take it out, and put it together with the screw. Remember the steps when disassembling, and the return is the same. Everything that has been removed should be put away in a unified way, and don't lose it.
3. Unscrew the screw fixing the lock cylinder and remove it to the lock cylinder. If you can't pull out the lock core by hand after removing the screw, knock it off with the left or right lock head of the hammer and try again. According to the method in step 3, install the handle after installing the lock cylinder anti-theft shell. Before installing the handle, insert the safety bolt and then install the upper handle.
4. Install the inner and outer handles of He Long. It is best for someone to help you hold it with your bare hands, so that you can meet each other symmetrically. Then proceed to the next step, adjust the inner and outer handles, and be sure to coordinate well. Align the screw hole with the nut over there, or turn the screw after polishing it with a flashlight.
5. Insert the screw vertically. If the internal nuts are not aligned when inserting the screws, please shake the screws with your fingers. Generally, friends who have screwed the screws will realize whether the screws are aligned.
6. Fix the panel and tighten the screws. Be careful that the screws are not too tight. When the handle is folded, it cannot rotate flexibly. Later, try the effect. Be sure to try again with the door open to avoid being locked. If the door is not repaired, you'll have to start all over again. You can twist the safety by inserting the key and turning it 360 degrees. When everything is normal, you can do it manually.