How to disassemble the MG gt heater box?

Remove the steering wheel first, then the instrument panel, and then the heater tank. Removing the heater box requires removing the central control instrument panel. Drain the coolant first, then remove the engine room heating water pipe, the center console, the entire heater box assembly and the heater box. (1) Drain the coolant from the cooling system.

(2) Remove the control panel.

(3) Separate the cable fixing piece on the left side of the heater and remove the screw on the terminal.

(4) Pull out the wire connector behind the blower motor.

(5) Disconnect the vacuum tube and lighting line behind the heater control device.

(6) Place a container under the heater water supply pipe behind the engine and cylinder head.

(7) Disconnect the heater water supply pipe behind the cylinder head.

Principle of warm air water tank: In addition to a radiator in the engine compartment, there is also a heat exchanger in the dashboard of the cab, and antifreeze used for heat dissipation in the engine flows in the middle. Turning on the warm air can improve the heat dissipation in the car, which is especially useful for some Jetta cars to run long distances. It uses the cooling water of the engine as the working medium, and blows it into the car room from the same air outlet under the action of the blower to achieve the purposes of heating, ventilation and defrosting. There are two main air intake methods: one is indoor air circulation, and the other is outdoor fresh air entering the car for ventilation circulation. The blower is electrically driven and influenced by the engine speed, so it can still be used for heating and defrosting even if the engine speed is very low.