What should I pay attention to when installing the bathroom partition?

1, after laying the floor tiles and wall tiles, do the bathroom partition. When decorating the bathroom, you should first lay floor tiles and wall tiles, and then customize the bathroom partition according to the actual size. Note: Before laying floor tiles, sewer pipes and floor drains must be installed. At the same time, it is necessary to consider the possible errors of the wall surface and customize the glass door according to the actual size for installation and use. 2. Consider whether the glass partition of the bathroom has a door frame to block water. If not, it is necessary to install a special threshold stone. Generally, the threshold stone should be 1.5 cm-2 cm higher than the ground. Otherwise, the shower water will flow out from the door, which will not achieve the purpose of dry and wet zoning, and it will easily cause inconvenience. Be careful, never use the slide, because the water and dust in the slide are difficult to clean, and it will stink after a long time. 3. The bathtub should be equipped with grab bars. The bathtub in the bathroom is a place where the whole family needs to take a bath. There are water, shower gel and other risk factors that are easy to slide down in the bathroom. Therefore, in order to ensure safety, it is best to install a handrail next to the bathtub, especially for the elderly and children at home, and pay more attention to this detail. 4. The electric plug should be far away from the bathtub, which is a container for storing water. It is best not to have electric plugs around, because under normal circumstances, many people will blow dry in the bathroom after washing their hair. If someone is in the bathtub at this time and the started electrical appliance falls into the water, it will be fatal. So it is best to install the electric plug away from the bathtub, just in case. 5, switching power supply to do moisture-proof measures The bathroom should be water-based at home, so in order to ensure safety, cable switches should be used in a planned way when decorating the bathroom, and it is best to add moisture-proof covers to electrical equipment such as power sockets. 6. Glass doors should be made of plexiglass or tempered glass. The glass door of the shower room should be plexiglass or tempered glass to avoid injury. If the glass is colorless, it is best to stick a pattern in a place far away from the line of sight to avoid damaging the glass.