Sticking method of wall brick

1. The interior wall tiles should not be soaked before preparing adhesive, but the loose materials on the back of the tiles should be removed with a wire brush, and the floating dust on the back of the tiles should be wiped off with a wet cloth. Then put the water or emulsion into the mixing barrel according to the proportion suggested by the manufacturer, and stir until the binder is uniform and does not agglomerate. After the initial mixing, the adhesive should be left in the mixing barrel and stirred until the curing time suggested by the manufacturer is over before use.

2. Stick the inner wall tile with the straight edge of the tooth spatula that meets the required thickness of the glue layer, batch the mixed glue on the base surface, and comb the glue layer into a uniform strip along the direction of the brick seam. The purpose is to control the thickness and dosage of adhesive and make the bonding area of ceramic tile more uniform.

3. Before laying the interior wall tiles, apply a thin layer of adhesive on the back of the tiles. This double batch method can ensure the quality and durability of the paste, although it takes a lot of materials and hours.

4. Stick interior wall tiles. During the drying time of the adhesive, press the prepared tiles into place, and gently rub them perpendicular to the carding direction to exhaust the air under the tiles. After the shop is laid in place, tap it with a rubber hammer, and adjust the surface flatness and seam flatness with a cross positioning frame of appropriate size.

5. The brick surface of the interior wall brick should be cleaned in time, especially to remove the residual adhesive on it. Qualified adhesive is not easy to be removed even after drying and hardening the ceramic tile surface. Isolation signs should be immediately placed on the cleaned ceramic tile surface to avoid pollution or interference until the next joint filling process.