The floor heating water separator is the hub of the whole floor heating system, which plays a vital role. The floor heating water separator is a shunt device that divides hot water or hot steam sent from the main heating pipe into several sub-pipes and sends them to each room. It is an essential equipment for floor radiation heating, and the floor heating water separator determines the service life of floor heating. So what is the function and working principle of the floor heating water separator? Working principle of the floor heating water separator: The floor heating water separator is the control center of all indoor geothermal heating, and it has the function of shunting and partial pressure. When the heat medium flows into the room, it enters the main bar of the water separator after passing through a multifunctional filter. In this link, the filter filters out impurities in the heat medium to prevent impurities from entering the underground pipe network and blocking the pipeline. The main bar is a horizontal device, so using the principle of the same height and equal pressure, the heat medium is evenly distributed to the branch pipes. After the heat exchange system, each branch pipe flows back to the main bar and then flows into the heating system from the water inlet. In addition, a water mixing device is added to the self-heating system, which means that after heat exchange, the temperature of the heat medium is still very high, and after passing through the water mixing system, it flows into the main bar of the water separator for continuous circulation, which can also save energy while heating.
the function of the floor heating water separator is to adjust the temperature; The floor heating water separator is used for diversion. If the whole boiling water flow is large and the circulation is fast, the indoor temperature will be high. If each valve is half-open, perhaps a single valve is half-open, the amount of hot water in the pipeline will be reduced, the water circulation will slow down, and the corresponding indoor temperature will be low. If the hot water is completely turned off, it will not circulate, which means that there is no heating in the room, so it is possible to adjust the indoor temperature by making good use of the geothermal water separator. Separate room heating; When the large-sized apartment is planned and installed in the geothermal system, outlet pipes and return pipe will be installed in different areas, and each water pipe corresponds to a water separator. When there is no one in an area for a long time, users can choose which water separator to turn off, so that the effect of heating in different rooms can be achieved. Shunt voltage stabilization; The water separator can shunt the water in the water pipes, so that each water pipe can achieve the effect of pressure balance. The inlet and outlet of the water separator have corresponding valves, which can adjust the water flow and achieve water flow balance.