1. What are the installation methods of faucets?
1. First, you need to put the hose into the faucet for connection, then connect the screw to the faucet interface and put the rubber ring on the faucet. Put the faucet into the basin, add the gasket and rubber pad, and finally fix the wrench and screw.
2. If the washbasin faucet is a hot and cold faucet, then the internal water valve is a tee and there is only one water inlet, so only one hose can be connected. The other hose should also be connected to the faucet, but the other section needs to be blocked. The hose of the faucet is only fifty centimeters, but it actually takes about sixty miles. Therefore, it is best to choose a matching 60 cm hose in the hardware store and connect it around the raw material line.
3. After the washbasin faucet is disassembled and installed, it can be cleaned and glued. Simply put, it is to close the main water gate first to avoid water splashing. Then remove the main water pipe connector and faucet connector. Remove the faucet nozzle and clean it. If the connecting pipe is rusty and difficult to disassemble, unscrew it with a wrench and then open the inside of the pipe to complete the disassembly of the faucet.
4. Be sure to turn off the main gate before removing the faucet, otherwise it will cause a large area of water leakage. When installing the faucet, the steps are similar, but the steps are reversed. Everyone must pay more attention.
Editor's summary: What are the installation methods of faucets? I believe everyone knows something after reading the article. I hope the above contents can bring some help and suggestions to everyone. For more information, please continue to follow us.