In the previous article, we introduced how to knit floor socks, how to make photo frames, and how to sit on the sofa. We have all these, but we are missing a DIY vase, so how do we fold the vase? Some people want to ask, if the vase is so big, how much paper do we need to fold it out? Don’t worry, then let’s do it The editor will take everyone to look at the relevant introduction to the exciting content of how to fold a vase.
1. How to fold a vase
1. First, fold the playing cards in half. If the pattern of the vase needs to be white, fold the front part of the playing cards outside the crease, as shown in the picture As shown; if the vase does not need to be white, put all the poker patterns on the outside of the creases. The one I am making now is white.
2. Open the folded playing card, and fold the two corners in the same direction in half again along the crease. Note that when folding this time, the crease cannot be pressed too deep. If it is pressed too deep, If it is, it will be difficult to insert it when it is assembled into a vase. Just fold it like this.
3. It looks a bit like the nose of an airplane, right? Then fold the tail of the airplane in the same direction
4. Finally, fold the "triangle" in half along the original crease , (let’s call it a triangle for now)
5. It doesn’t look good if you leave a small “tail” on each side, right? It doesn’t matter, let’s get rid of them. There are two ways
a. If you have scissors beside you, just cut it off. It is convenient and quick.
b. If you don’t have any scissors around you when folding this, just fold it in as shown in the picture
6. All steps for accessories are completed Now, let’s take a look at the results:
7. To make a vase, you need a lot of triangles like this. I am folding the white ones now to make the vase neck. Let’s take a look at the other colors of my vase. Okay,
8. Okay, all the accessories are completed, let’s start assembling the vase: Insert the corner of one triangle into a slit on the back of another triangle. The inserted triangle is the base of the vase. Oh, choose the color according to your preference. I am using purple as the base here. I made a rhombus pattern for the main body of the vase. The red part is in the middle of a rhombus. I use five triangles of the same color. The rhombuses are separated by triangles of a darker color to make the flower shapes more distinct. I use blue here. Colorful
9. Let’s look at it from another angle
10. There is another thing that needs to be reminded here, that is, the corners of the first circle on the base of the vase should be a little more prominent. Oh, otherwise the vase will have a big belly and be unsightly.
11. Okay, just stick it on circle by circle. Be careful to use glue. I used milky white glue. When I first started using synthetic glue, I always felt it wasn’t sticky, so I changed it to Milky white glue. In the lower part of the vase, the circles are larger than each other, and in the upper part, the circles are smaller. Make half of the vase and take a look
12. Take a look from the inside again
13. Glue it round and round, the bottle body is done and the bottleneck is just a little bit The method is different. Do you see the blue circle? The blue one is still the same as before. The blue one needs to be glued in reverse, just like in the picture.
The top of the bottleneck First, one circle should be smaller than the other, and then the next circle should be larger than the other, and two corners should be inserted into the holes on the back of the triangle in the second circle. Glue them together slowly, and it will look like this
14. Take a look and it’s basically done
15. Okay, the practical, beautiful and economical poker vase is ready. Do you like it? It’s really grand and luxurious!
2. Notes:
1. The most difficult thing to start is the first round. After completing the first round, you can fix it with a rope before continuing to add the second layer.
2. When closing, be sure to insert it upside down and reduce one in each circle.
3. It is best to choose soft glue such as white latex for glue. Ordinary glue will harden after it dries and will deform when pressed.
4. Generally, the first layer starts with 54 cards, and each layer adds one closing card and each layer subtracts one, which takes about 15 decks.
Practice produces true knowledge, and hands-on practice produces results. Try it yourself a few times.
How about it? After reading the above introduction on how to fold a vase, you learned a lot about how to fold a vase. I hope you can learn more about home decoration through this article and be inspired by it, so as to create a more perfect home environment. Thank you for reading this article and for your strong support and love for the editor. If you want to get more home decoration information, please continue to pay attention.