1. Before the floor heating water separator is deflated, the drain pipe and washbasin should be prepared first, because a large amount of water will flow out during deflation to prevent the ground from getting wet.
2. Then we need to find the inlet pipe and outlet pipe, close the valves, open the water valves of each branch pipe, and turn it to 90 degrees to start deflation. Generally speaking, gas is discharged first, and then water will flow out.
At first, the water was turbid and the water temperature was low. After putting a few pots, the water temperature will gradually increase and the water will gradually become clear. Wait until the water inside is clean, then put the second and third root, and wait until all the water separators are released.
Installation method of floor heating water separator
1. When installing the floor heating water separator, it should be noted that each water inlet and outlet should be connected with the water separator, and generally there should be no more than 8 branch pipes, otherwise it is too dense, which is not conducive to installation and will make the heating system cycle not particularly good.
2. It is necessary to set two valves in the water separator, which are mainly used for cleaning the filter and closing it when replacing the filter. Bypass should be set, and valves should be set in the bypass, which should be connected before and after the inlet valve to ensure that the water in the heating system will not flow into the heating pipeline.
3. We can set up an automatic or manual water separator, which will be more convenient to exhaust, avoid system blockage and solve the problem that the heating effect is not particularly good.