Where is the Honda Binzhi antifreeze location and how to add Binzhi antifreeze The location of the Honda Binzhi antifreeze coolant is as shown in the picture: Step 1: Inspection First do a comprehensi

Where is the Honda Binzhi antifreeze location and how to add Binzhi antifreeze The location of the Honda Binzhi antifreeze coolant is as shown in the picture: Step 1: Inspection First do a comprehensive inspection and see Check whether there are any traces of cracks or leaks in the pipes. Focus on checking the bottom bracket pipe (so named because there are five interfaces connecting various parts). Antifreeze must flow through the bottom bracket pipe and then be distributed to different parts of the car to play its role. Step 2: Clean and release the old antifreeze, clean the liquid channel with clean water, add the clean water to the antifreeze replenishment tank, and then inject clean water into the tank to allow the clean water to flow continuously through the engine cooling system, and then start the car at idle speed for 3 to 5 seconds. Let the water circulate for a few minutes. The water that starts to flow out of the water tank will be a little light pink. Continue to pour in clean water until the water that flows out is clean. Don't forget to remove the heating water pipe and drain the water in the heating water tank. Step 3: Replace the antifreeze. In order to allow the antifreeze to flow into the water tank quickly, drain the water for about 1 hour and then add new antifreeze from the water tank (heat sink). Add another bucket of antifreeze to the antifreeze tank until the antifreeze tank is almost full. Ignite the car for about 10 minutes. At this time, the cooling system has eliminated some air and the liquid level has dropped. Then add the antifreeze, the amount should be between the maximum (MAX) and the minimum (MIN).