How to open the floor heating?

1. This is an introduction to the simple structure of the floor heating water separator, which mainly includes: water supply and return valves and water supply and return branch valves.

2. First, open the water supply and return valves.

3, and then open the water supply and return branch pipe valve.

4. Open the water supply and backwater branch valves one by one, and pay attention to the best towel to prevent water spraying when the air pressure is unbalanced.

5. Finally, all branches can be opened.

Extended data:

Pay attention to when using floor heating:

1. First, turn on the floor heating thermostat in each room (press and hold the "I" key for 5 seconds to turn it on, press and hold it for 5 seconds to turn it off, and press the "∧" and "∨" keys to adjust the room set temperature).

After 2.5 minutes, turn the knob on the left side of the boiler to 55 degrees. If F28 appears, the gas may not be turned on. After turning on the gas, press the reset button marked with flame; If "F22" appears, press the "One" key to see the pressure, which is within the range of "0.8-2.4" (preferably within the range of 1.5-2.0).

3. The floor heating is tried for 24 hours, and the room effect is obvious; During the initial test, try to open all temperature control panels in all rooms and adjust them to the appropriate temperature (such as 23 or 25 degrees).

4. When the floor heating is not used for a long time, please turn the floor heating temperature adjustment knob on the left side of the boiler to the end in the "-"direction.

Baidu encyclopedia-floor heating

Baidu encyclopedia-floor heating installing