Strawberry origami tutorial video

The video about strawberry origami tutorial is as follows: Strawberry origami tutorial video

Prepare square paper. Fold diagonal and opposite sides, and expand. Fold it into a square along the crease. Fold the upper edge toward the center line. Then fold the lower edge towards the center line. Expand. Then fold it back. All the corners should be folded like this. Fold all four triangles. Finally, expand it.

I use two colors of paper to fold, which is very thick and difficult to fold, so it is better to use double-sided paper if there is double-sided paper.

Take a piece of red square paper. Fold the rice crease (preferably the horizontal line and vertical line are folded in half, and the diagonal line is folded in half), pinch both sides of a horizontal line, and exert force in the middle, as shown below, and then fold a smaller square.

Fold according to the following steps. The photo shows that the upward corner is the center of the original paper. ) As shown below, fold the crease, then open it, flatten it, align it, and the two sides are consistent.

Fold the triangle below, as shown below. Turn the paper over and repeat the steps in the third, fourth and fifth pictures above. Fold the two folded faces to expose the other two unfolded faces, and fold one face as shown in the figure below.

Fold the other side in the same way. Put your finger in, lift it, adjust the shape, and then fold back the four small triangles, as shown in the figure below. After the strawberry is partially folded, continue to fold the green leaves and take a piece of paper that is only a quarter of the size of red paper, green square paper. Fold the rice noodles.

Fold a small square like the strawberry part at the beginning, and then continue to fold in half. Draw the shape of a small leaf and cut it along the line.

After cutting off the lower end of the small leaf, subtract a little sharpness, just a little. After unfolding, gently pinch your nails on your fingers and pull out the curvature of the leaves.

Fold twigs on the leaves as shown below. If they are too long, cut short parts and adjust them randomly. Then insert it into the small hole in the middle of the leaf. Use glue, tape and the like, and use your intelligence to stick the leaves and strawberries together. Draw some small black dots with black strokes, and it's done.