1. First, fold the playing cards in half. If the vase pattern needs white, fold the front of the playing card beyond the crease. If the vase doesn't need white, put all the poker patterns on the outside of the crease.
2. Open the folded playing cards, and the two corners in the same direction are folded in half again along the crease. Be careful not to press the crease too deeply when folding this time. If you press it too deeply, it will be difficult to insert it into the vase at the back.
3. It's a bit like the nose of an airplane, and then the tail of the airplane folds in the same direction.
Finally, fold this "triangle" in half along the initial crease.
5, leaving a small "tail" on each side is not good-looking, this is the way to get rid of them, there are two ways:
First, if you have scissors with you, cut them off.
Second, if you don't have scissors with you, fold them as shown in the picture.
6. After the accessories are finished, start to assemble the vase: insert the corner of one triangle into a seam on the back of another triangle. The inserted triangle is the base of the vase. Choose the color according to your preference. I made a diamond pattern on the front of the vase. The red part is in the middle of a diamond with five triangles of the same color. I used a darker triangle to separate the diamond from the diamond to make the flower shape more distinct.
7. Stick around like this. Pay attention to using glue. The lower part of the vase is bigger than the first one, and the upper part is smaller than the first one.
8, a circle of glue, the bottle is ready, the bottleneck is a bit different. The top of the bottleneck is smaller than the first circle, and then larger than the second circle. The two corners are inserted into the back of the triangle of the second circle and slowly stick together, and that's it.
9. Well, the practical, beautiful and economical poker vase is ready.
Precautions:
1 The hardest thing to start is the first lap. After the first lap, you can fix it with a rope, and then continue to add a second layer.
When closing the door, be careful to insert it backwards and throw one in each lap.
It is best to choose soft glue such as white latex as glue. Ordinary glue will harden after drying and deform when pressed.
Generally, the first floor starts with 54 sheets, and each floor is increased by one sheet, and each floor is decreased by one sheet, which is about 15 pairs.