Underfloor heating
Two. Methods/steps
1. This is an introduction to the simple structure of the floor heating water separator, which mainly includes a water supply valve and a return valve.
2. First close the water supply and return valves.
3, and then close the water supply and return branch pipe valve.
4. Then open the branch valves of water supply and backwater one by one to deflate.
5. Finally, open all branches and try to see if there is any discharge.
6. Finally, open the water supply and return valve and exhaust.
Extended data:
Matters needing attention in using floor heating:
Before installing floor heating, you should first choose your own satisfactory floor heating. Floor heating should be easy to use and of good quality. However, when choosing floor heating, many people easily go into the wrong area. Let's first understand the misunderstanding of the choice of floor heating, so as to avoid being at a loss when choosing, or walking into a minefield when choosing.
Many owners believe that floor heating should keep the floor surface warm and dry while keeping it moist. Actually, it's not. Floor heating is to use heating cables to heat rooms, so it is more suitable to use floor heating in large spaces. It is not recommended to use floor heating below 60 square meters to avoid excessive waste.
Some people think that the copper radiator for floor heating is more corrosion-resistant and of better quality. In fact, copper radiators encounter sulfur in the soil, which is often too high and easy to cause corrosion. Therefore, if the copper radiator is used, it needs to be cleaned regularly to avoid sulfur corrosion.
When the floor heating is installed, the installation should be safe and planned. The installation of floor heating is not without layout. On the contrary, the layout of floor heating installation needs to be careful. It is necessary to consider the layout of floor heating according to the use area and insulation effect of the room, design the reasonable direction and spacing of floor heating pipes, provide the most suitable heat dissipation for the room according to the radiation principle, and make accurate calculations to achieve the best effect with the least number of pipes.
Therefore, the use of floor heating is not as dense as possible. If the distance between the plates of floor heating is too large, it will cause the indoor temperature to be too high and very hot, which will affect people's health. At the same time, the installation of floor heating does not mean that air conditioning can no longer be installed, because floor heating can only achieve the effect of heating, and when cooling is needed in summer, our air conditioning is still needed to exert its strength. Therefore, air conditioning should be properly installed at home to avoid being caught off guard when it is hot.