How to remove the heating water pipe of Passat 2.8v6 cylinder?

If you need to remove the heating water pipe, you must go to the 4S shop or garage to remove the car heating water pipe. It is strictly forbidden to disassemble the heater tube of Fox without authorization, so as to avoid the failure of the heater of the car.

How to remove the heating water pipe of Passat 2.8v6 cylinder block:

1, the state of the car.

2. Identification of joint identification.

3. Identification of water pipe quick connector.

Step 4 remove it.

5. install.

The use of automobile warm air is introduced as follows:

When the car just started, the internal lubrication of the engine was not enough and the temperature of the water tank was relatively low. At this time, turning on the warm air is not only not conducive to the increase of the temperature in the car, but also increases the load of the engine, and the fuel consumption is certain.