1, when adjusting the float, roll enough lead on the lead base first, so that the whole float can be dragged below the water surface when it is half full.
2. Throw the empty hook into the fishing spot and adjust the position of the float until the float is exposed a little. At this time, the lead has reached the bottom.
3. Adjust the float downward by a certain distance: the length of the brain line+the height of the tail of the float above the water surface+about 20 to 30 cm. At this time, when you throw it into the fishing point, the floating tail will be completely dragged below the water surface by lead (because the fishing line also has certain gravity and buoyancy, the closer it is to the bottom, the more accurate it is, so it is divided into two steps).
4. Reduce the weight of lead skin, throw it into the fishing point again, and repeat the operation until the floating tail is above the water. At this time, the number of exposed eyes is not adjusted.
5. Press the tip of the fishing rod into the water, so that all the floats are submerged below the water surface, and then return the fishing rod to normal. The float will float slowly from the water surface, exposing a certain number of floating tails. Although lead is not increased or decreased, the mesh number at this time may be different from that in step 4, and this number is accurate adjustment.
6. If you are not satisfied with the adjustment, you can continue to increase or decrease the lead skin and repeat step 5 to determine whether the adjustment has reached your goal.