First of all, the living room
1, wall
Observe whether the indoor wall color is even and smooth, and whether there is uneven and unsmooth color. In addition to white paint, other colors of paint are prone to uneven chromaticity, especially at the junction of wall facade and ceiling, which is the most prone to problems.
2, the ground
Check whether there are obvious cracks and unevenness on the floor, walk slowly in each room and listen carefully to the creaking noise. When checking, focus on observing whether there is looseness and fluctuation at the entrance of the floor, the joint with the balcony and the four sides near the wall.
3. Door/entrance door
Focus on checking whether the door opening and closing is quiet and smooth enough, and whether the hardware such as the door handle is loose or corroded.
4, access control system
At present, many access control systems are visual intercom. Pay attention to test whether the bell is normal, whether the intercom sound is clear, whether the image is complete and whether there is shaking.
5. (power supply) socket
See whether the installation position of the socket and the position of the telephone line are reasonable, and check whether the circuit of each socket in the living room is normal and available.
6, air conditioning position and power supply
Whether the reserved position of air conditioners (mainly vertical air conditioners) is reasonable is very important. In addition, it is also important to observe whether there are corresponding holes and power supplies next to the reserved position of the air conditioner.
Second, the bedroom
1, wooden floor
The most common problem of wooden floor is bulging. Focus on observing whether there is looseness and fluctuation at the entrance to the floor and around the wall. Pay attention to the gluing of the baseboard. Those that are not glued must be glued, and those that are deformed must find out the reason of deformation, and then ask for replacement after eliminating the reason.
2. Circuit
First, check whether the circuit of each socket in the bedroom is smooth and normal, focusing on whether the telephone line in the bedroom is in place. Secondly, it depends on whether each socket panel is in good condition, whether it is installed correctly and whether the installation position is reasonable.
3. bay window
Check whether the air tightness and sound insulation performance of bay window are good, and pay attention to whether the joint between bay window and wall is tight. Check whether the opening, closing and pushing of the lower window are smooth and noiseless. If you buy a house on the first floor, you should also pay attention to whether the guardrail outside the window is firmly installed and rusted.
4. Hardware
Pay attention to whether the hardware installed on the bedroom door and bay window is loose, switch it on and off several times, and listen to whether there is abnormal sound. If it is an installation problem, please reinstall it. If it is the quality problem of the hardware itself, it needs to be replaced immediately.
Third, the kitchen.
1, kitchen wall
Most of the kitchen walls in hardcover rooms are ceramic tile walls, which are prone to color difference, too large or uneven laying gap, cracks in corner tiles and gaps between tiles and walls. Tap the wall with your finger. If there is a tapping sound, it means there is a hole.
2. Kitchen flue
It is best to open a part of the ceiling to see if the smoke pipe of the range hood is closely combined with the flue, otherwise there may be a phenomenon of "inverted smoke" in the future.
3. Kitchen ceiling
For the ceiling of the kitchen, it is mainly observed whether there are problems such as uneven joints, poor flatness, arching of the ceiling, uneven corners, displacement and deformation.
4. Kitchen cabinets
Look at the cabinet for deformation and bubbles first, and then look at whether the stone cutting of the cabinet is fine, straight and intact. In addition, looking at kitchen hardware, hardware with smooth opening and closing, low noise and no rust is qualified.
5. Reserve refrigerator space
This is very important, depending on whether the reserved refrigerator space is reasonable and whether there is a refrigerator socket next to it. If the refrigerator you buy is too big or too big, it will waste space, and if the socket setting is unreasonable, it will also bring trouble to use.
6. Kitchen power supply
Electric appliances such as rice cookers, microwave ovens and kettles in the kitchen are still often used. Pay attention to whether the power supply quantity is sufficient and whether the power supply position is reasonable when inspecting the house, so as to facilitate the application of kitchen appliances in the future.
7. Pipeline gas
Put a smoking paper roll near the alarm device to see if the device is sensitive; When the alarm sounds, the air intake solenoid valve will be closed. If not, it should be repaired in time.
Fourth, the bathroom.
1, waterproof performance
Pour a lot of water on the ground to see how fast it drains and whether there is water. In addition, first block the drain, and then pour a certain amount of water on the ground to inform the downstairs owners to observe whether there is water leakage.
2. Ventilation performance
Good ventilation is one of the important conditions to keep the bathroom clean and dry. I suggest you buy a Wei Ming with good lighting and ventilation.
3. The quality of bathroom equipment
For the acceptance of finely decorated bathrooms, it is also necessary to check the quality of bathroom equipment. The launching of toilet equipment should be smooth and easy to use, without blockage or leakage. Finally, check the outlet of shower head, bathtub and faucet. The requirement is that the outlet is unobstructed and there is a certain water pressure.
The above are some details of the inspection of the hardcover room. Before the inspection, there are still some preparations to be done. For example, check whether the house quality guarantee, completion acceptance record, area measurement table and pipeline distribution completion drawing (water, strong electricity, weak electricity, structure) are complete; And confirm whether the attached drawings of the sales contract are consistent with the reality, whether the structure is the same as the original design, whether the housing area has been measured by the real estate department, and whether it is different from the area agreed in the contract.
(The above answers were published on 2017-10-12. Please refer to the actual situation for the current purchase policy. )
When buying a new house, go to Sohu Focus.