There is a telephone pole in front of the grave. Is there a problem?

It is unlucky to have telephone poles in front of or on the right side of the grave, and it is also unlucky to have wires passing through the grave. The poles in other directions are fine. If there is a pole in front of the right, move it to the grave. There is no solution.

Process flow:

Processing and manufacturing of steel bars: cold drawing, cutting, bending and binding of steel bars. Processing and manufacturing of reinforcing bars: cold drawing, cutting, bending and binding of reinforcing bars, and concrete batching.

Mixing system: concrete batching and mixing. Pole forming: centrifugal forming of circular poles (centrifuge, mold and cloth machine are required), or vibration forming of other types of poles (cloth machine, vibration table, mold and other equipment are required).

Steam curing: let the newly formed polar strip stand for a period of time, and then enter the steam curing room for curing for several hours.

Demoulding and curing: take the pole together with the mold out of the curing room, demould and clean the mold, and keep the demoulded pole wet or soaked in water for a period of time. Mold investment is large, and production efficiency depends on the turnover rate of mold.

The steel mold consists of two half molds, which are used to feed and take out finished products. Therefore, before molding, it is necessary to mix and stir the steel skeleton (steel cage) of the telephone pole with cement slurry (cement+gravel+sand+water) that meets the proportional requirements, so the production principle is simple, but certain lifting equipment, site and mechanical equipment are needed.