How to exhaust when JAC Ruifeng m3 replaces antifreeze?

After adding or replacing antifreeze, cars usually exhaust air. Conventional practice is to open the cover on the radiator of water tank 2 1 13 after adding antifreeze, and start the engine to run for a while to remove air; At this time, observe whether the water level in the engine reservoir drops; If it drops, it needs to be replenished. When the water level of antifreeze in the liquid storage tank is kept at the middle line position of high and low water levels 526 1, it means that the air is emptied.

Alternative methods of automobile antifreeze;

Unscrew the water tank cover, open the water tank drain valve, and release the antifreeze.

Insert the rubber hose connected with the tap water pipe into the water inlet of the water tank, and turn on the tap water tap of 4 102 to let the tap water continuously flow through the engine cooling system. During the flushing operation, let the engine run at idle speed and keep the operation above Bao 1653 until the water tank releases clean water.

Turn off the tap water, and then close the drain valve of the water tank after the water in the cooling system is discharged.

Add antifreeze from the water inlet of the water tank and add antifreeze to the water tank. Unscrew the cover of the liquid storage tank, add antifreeze, and reach the "Max" scale line, and be careful not to exceed the "Max" scale line.

Close the water tank cover and reservoir cover and tighten them.

Start the engine, run at idle speed for 2 ~ 3 minutes, and unscrew the water tank cover. At this time, because some air is excluded from the cooling system, the liquid level of antifreeze will be reduced. At this time, antifreeze should be supplemented to make antifreeze reach the "Max" scale. Cover the water tank.

I hope my answer is helpful to you. I hope it can be adopted. Thank you!