Does the simple European style porch look good with the cultural stone?

Decorating the entrance with cultural stones is of great benefit. Cultural stone, scientifically known as cast stone, is defined as "fine building concrete unit manufacturing, simulating natural cutting, and taking stone for unit masonry application". Cast stone can replace natural stone such as limestone, brown sandstone, sandstone, bluestone, granite, slate, coral stone and lime. The construction of cultural stone is very different from ordinary wall construction.

First, clean the wall and make a rough surface. In the case of glossy surface with low water absorption, such as plastic wood, it is necessary to lay barbed wire and make a rough bottom, and then lay it after full maintenance.

Second, before sticking the rocks, you must arrange the rocks on the flat ground to get the best effect, and then lay them in the order of arrangement. Don't be adjacent to rocks of similar size, shape and color.

White cement above 3.425, ordinary cement (cement: sand: 80 1 glue ratio 1: 2: 0.05) and ceramic glue (please pay attention to the instructions of glue) can be used as adhesives.

Fourth, fully wet the rock, and coat the adhesive on the center of the bottom of the rock to form a mountain shape (when pasting antique bricks, the bottom of the brick can be coated with a thin layer of adhesive). If the surface is dirty in a large area, it should be cleaned up with a brush before use.

Fifth, stick it in the corner first. Press enough to make the adhesive squeeze out around the rock (some products don't need corners).

Six, such as construction needs, can be adjusted to cut the rock.

Seven, fill the gap with plastic bags filled with pigments, pay attention to the depth, the deeper the gap, the better the three-dimensional effect of the product.

Eight, after the initial setting of the sealant, remove the excess sealant with bamboo chips. , and brush dipped in water to repair the crack surface. If a small amount of caulking agent or adhesive is accidentally stuck on the rock surface, dry it and remove it with a brush. Much better. Some products don't need to leave seams.

Nine, when the stone is used outdoors, after the completion of paving, after the products and caulking agents are completely dried, protective agents can be sprayed for protection (waterproof, anti-freezing, anti-ultraviolet, anti-alkali and other characteristics).

X. Requirements for joint retention: deal with (1) disordered rocks-the minimum joint circumference is about 10mm, and the difference of disordered size is adjusted by caulking agent.