1. The induction faucet does not produce water.
When using (1), it was found that the induction faucet did not produce water. No matter how you put your hand, there is nothing wrong with it. The first reaction was that something had happened. First, check whether the power supply is normal. At present, the main power supply mode is AC 220V transformer, 12V, 6V. The direct current is 46V, usually using four alkaline batteries No.7 or No.5. If it is 3V, you need two alkaline batteries No.7 or No.5..
(2) Try to put your hand in its set position and check whether the indicator light in front of the infrared window is long. Because the infrared window of some induction faucet brands is controlled by single chip microcomputer, the power indicator light is in the water control part, and most of them are installed under the basin. If there is no response, there may be something wrong with the sensing part, and the corresponding infrared probe needs to be replaced.
(3) After the replacement is completed, check whether it can be used normally. The problem is solved, which means it can be used normally. If there is a problem, you can plug the infrared part into the water control part of the faulty faucet first, and you can know whether it is the problem of the induction part or the solenoid valve of the water control part by replacement method, and then carry out corresponding maintenance.
2. The induction faucet is not closed tightly.
(1) When people withdraw their hands, water will still flow out of the induction faucet, and it will still be like this after the 5-level wind. There may be a foreign body in front of the sensor window. Check it carefully first. If there is one, clean it up and check its condition. It can basically be repaired.
(2) If the indicator light is normal, there is still water leakage. Check whether the filter screen at the water inlet end of the water control part is blocked by sediment or other sundries. If yes, clean it first, see if the faucet can be repaired, and then check it regularly.
3. The output of induction faucet is small.
(1) When washing your hands, sometimes you will find that the water output is relatively small. On the one hand, it depends on the water pressure and the flow of the pipeline itself. If the water flow is low due to low pressure or blockage, you can adjust the pressure or clean up the garbage in the pipeline.
(2) It is also possible that the filter screen at the inlet end of the water control part is blocked by impurities, and the pipeline generally adopts PPR. During the construction of some projects, the pipe joints are hot-melted. It is not ruled out that excessive hot melting will deform the pipeline and reduce the amount of water flowing into the pipeline, so you should always pay attention.