Application: Strengthen floor soaking.
Improvement scheme: it is not recommended to pry up and dry the reinforced floor whether it is flooded in a large area or a small area, which may easily cause damage to the reinforced floor and may lead to serious consequences that it cannot be used again. It is best to drain the surface water of the floor quickly, then take off the baseboard of the floor to expose the expansion joint, and rely on the expansion joint to dissipate water vapor. But according to the size of the water, it usually takes about seven to fifteen days to dry. For products with good quality or short soaking time, they can be recovered by themselves. If/kloc-cannot be recovered after 0/5 days, it should be replaced again.
Coup 2: pry up the wooden floor and pile it in the shade in a "well" shape.
Application: pry the floor after soaking in water.
Improvement scheme: For the wet floor, it is very important to dry it in the shade while keeping the floor as flat as possible. After the floor surface is dry, it can be stacked in the shape of "well" to prevent deformation due to the weight generated by stacking. When placing, pay attention to the reverse side of the floor facing upward to prevent the surface from cracking due to rapid drying. At the same time, be careful not to be exposed to the sun, and put it in a ventilated place to dry in the shade. Generally, it can be reused for solid wood and multi-layer solid wood with good quality. In addition, in case of water leakage, it is necessary to inform the floor after-sales service office at the first time, and the staff will provide the best solution for the owner in combination with the floor's own situation.
Coup 3: pry up the vents on both sides while leaking water.
Application: solid wood floor with keel, small area soaking.
Improvement scheme: if water enters a small area in time, the board can be pried up after the ground is cleaned, and the wet floor can be reinstalled after drying; If the water inflow is slightly larger, not only the board at the leaking place should be pried up, but also the opposite board should be pried up along the keel arrangement direction to let the circulating air inside take away the water. If you can't determine the size of the water inflow, it's best to pry up the boards in turn to check the humidity according to the flow direction of the water inflow, so as to be foolproof.
Application: directly paved into solid wood floor with small water area.
Improvement scheme: If water is found in a short time, you can use a high-power vacuum cleaner to suck out water vapor. However, if there is water in a large area, all floors should be pried up and dried in the shade according to the second scheme. At the same time, if the indoor humidity is high and conditions permit, a dehumidifier can be installed indoors, which can drain the indoor humidity in a short time, but this operation scheme requires the floor dryness identification technology.
This answer comes from Xi 'an Xiegong Decoration Team, a good user. For more decoration strategies and home experience, welcome to visit the Good Life APP.