Which is the most practical, aquaculture water heating boiler or hot blast stove?

Through the long-term production practice of Nongshengle hot blast stove, people realize that only using hot air as medium and carrier can greatly improve the utilization rate of heat energy and the effect of hot processing. As a kind of thermal machinery, hot blast stove has become a substitute for electric heating source and traditional steam power heat source in many industries. Nongshengle hot blast stove will solve the cold problem of farm in spring, summer and winter for you.

Advantages of Nongshengle hot blast stove;

1, rapid temperature rise: when the boiler is started, the indoor temperature will rise and reach the set temperature soon.

2. Temperature control: the temperature can be adjusted at will according to the temperature required by chickens, pigs, rabbits and birds in different periods. If it is lower than the set temperature, it will automatically heat up; If it is higher than the set temperature, it will automatically stop accumulating.

3. Humidity control: This kind of boiler uses bellows to send hot air indoors, and at the same time, oxygen can be properly adjusted.

4. Sterilization and disinfection: While heating, the boiler can instantly kill bacteria and viruses in the air and purify the air.

5. Physiology: The boiler can automatically control temperature, humidify, stop and automatically store water, with simple operation and no heavy manual labor.

Installation instructions of Nongshengle hot blast stove

No matter the length, width and width of the house, the hot blast stove is placed in the middle of any wall opposite the sidewalk, and it is easy to pass. On the wall, measure the height from the ground and cut a square hole 300CM*600CM wide. The ground must be smooth. Then, align the inlet of the gate with the square hole, and the square hole is only supported by the wall, so that the hot blast stove is parallel to the wall and vertical to the ground without gaps. The tuyere of the fan should be aimed at the hot air inlet, the screws should be tightened, and a paper pad should be added at the tuyere to prevent air leakage. Finally, the chimney should be connected, and the chimney pipe is generally perpendicular to the hot blast stove. Special circumstances require separate design and installation. After installation, the hot blast stove is located at the outdoor fuel point, and the indoor temperature rises. Smoke and dust released by fuel are discharged from the indoor chimney pipe, and a small part is discharged from the feed inlet, thus fully keeping the indoor air clean.